To change the height of the toestop, use a 5mm allen key to loosen the toestop screw.
The recommended distance from the ground is the one shown in the photo.

To avoid unwanted injuries or damages, avoid a toestop position that is too low with respect to the skating surface.
Make sure NOT to unscrew the tip of the toestop stem lower than the locking screw.

It is advised to verify the condition of your equipment at every use.

In particular, it is advised to check:

• The correct tightness of the toestop screw, checking that the toestop does not rotate
• The presence of grease on the toestop thread to guarantee a tight seal
• not to tighten the toestop screw with excessive force to avoid stripping the thread.

It is recommended to substitute toestops when necessary to guarantee optimal performance.
Use the following photo as a guide for the MAXIMUM permissible level of wear of the toestop.
The excess use of the toestop can result in the exposure of metal parts which may be dangerous and may damage delicate surfaces (e.g., hardwood, parquet).